1937 Pontiac F-end

[Anthony]

Could anyone steer me in the right direction,
I have a 1937 Pontiac in which I intend to rod
using a ford clevland and auto and probably a ZA faiflane diff
or nine inch. I would like to do something with the front end
either a Holden HK,HT or L300 or maybe even drafting a HQ,HZ front
subframe to it.
If anyone knows of anyone who has done something similar
or were I can get some advice would be greatly appreciated
                                                                Thanks Anthony

[donsrods]

I think it was Street Rodder Magazine who did a series of articles on a Pontiac of about this era. They used a 389 Pontiac engine, and I think did some subframe swap.

I remember the article, but not many specifics. I think they have an archive that you can research for various articles.

I think because of the size and weight of this car, the typical MMII stuff might be a little on the light and narrow side. But maybe not.


Don

[enjenjo]

Here's the guys to give you the info you need. Here in the US, we don't have the Holden suspensions.  

http://www.ozrodders.com/board/index.php

[Anthony]

Here's the guys to give you the info you need. Here in the US, we don't have the Holden suspensions.  

http://www.ozrodders.com/board/index.php

Thanks for that, I realized this was a U.S. site after I made the post.
Rodding Roundtable was found on an Aussie site so I assumed it was Aussie.
Anyway Thanks again will try the link you sent.
                                                                    Anthony