1937 Pontiac F-end

Started by Anthony, April 23, 2006, 05:03:36 AM

Previous topic - Next topic

0 Members and 2 Guests are viewing this topic.

Anthony

Could anyone steer me in the right direction,
I have a 1937 Pontiac in which I intend to rod
using a ford clevland and auto and probably a ZA faiflane diff
or nine inch. I would like to do something with the front end
either a Holden HK,HT or L300 or maybe even drafting a HQ,HZ front
subframe to it.
If anyone knows of anyone who has done something similar
or were I can get some advice would be greatly appreciated
                                                                Thanks Anthony

donsrods

I think it was Street Rodder Magazine who did a series of articles on a Pontiac of about this era. They used a 389 Pontiac engine, and I think did some subframe swap.

I remember the article, but not many specifics. I think they have an archive that you can research for various articles.

I think because of the size and weight of this car, the typical MMII stuff might be a little on the light and narrow side. But maybe not.


Don

enjenjo

Here's the guys to give you the info you need. Here in the US, we don't have the Holden suspensions.  

http://www.ozrodders.com/board/index.php
Welcome to hell. Here's your accordion.

Anthony

Quote from: "enjenjo"Here's the guys to give you the info you need. Here in the US, we don't have the Holden suspensions.  

http://www.ozrodders.com/board/index.php

Thanks for that, I realized this was a U.S. site after I made the post.
Rodding Roundtable was found on an Aussie site so I assumed it was Aussie.
Anyway Thanks again will try the link you sent.
                                                                    Anthony