A coupe update

Started by moose, June 11, 2014, 11:51:56 PM

Previous topic - Next topic

0 Members and 2 Guests are viewing this topic.

Print
Go Down Pages1
User actions

moose

June 11, 2014, 11:51:56 PM
I have been making a little progress on my Coupe project. Currently fixing mistakes from my unknowing youth and poorly patched rot covered up and discovered...

The panel below the deck lid was butchered with badly installed lights and rust. Having heard horror stories about the bad fit of replacement panels I decided to fabricate my own.

I needs a little trim at the top and tip the edge over the inner structure and then on to the wheel well panels and a roll pan to finish the rear...

moose

#1
June 11, 2014, 11:52:47 PM
Well hell the pictures are reverse order...Oh well!

enjenjo

#2
June 12, 2014, 03:13:08 AM
Nice Job.
Welcome to hell. Here's your accordion.

416Ford

#3
June 12, 2014, 08:00:05 AM
I agree. Nice job.
You never have time to do it right the first time but you always have time to do it again.

kb426

#4
June 12, 2014, 12:55:23 PM
Well done. Sometimes we think backwards so pics in reverse make sense. :)
TEAM SMART

jaybee

#5
June 12, 2014, 10:01:25 PM
Well, you did reverse engineer your replacement panel.
Rudeness is the weak man's imitation of strength. Eric Hoffer  (1902 - 1983)

idrivejunk

#6
June 12, 2014, 10:03:46 PM
Very nice! Looks just right on there.
Matt

chimp koose

#7
June 13, 2014, 11:34:15 AM
You were right about the replacement panels. The only ones that I bought and can use 'as is' are the rear pan under the trunk lid, hood shelves and the running board aprons.most of those are pressed steel parts.The trunk lid and rear inner fenders for my T are not useable.Nice work on your part bye the way!
Print
Go Up Pages1
User actions