1939 chevy dash

Started by trackster, May 26, 2021, 03:37:45 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

trackster

Just wondering if anyone has used the */Absolute sheet metal dash for a 1939 Chevy. It is a replacement for the original but has a flat face for gauges.  How was the installation and fit?  Thanks for any info you can give.
I am CDO, kinda like OCD, but in alphabetical order, like it should be!

enjenjo

I can't speak for that particular dash, but I have used their 40 Ford dash and it fit perfectly.
Welcome to hell. Here's your accordion.

trackster

Thanks for the reply.  Sounds like they have done their homework.
I am CDO, kinda like OCD, but in alphabetical order, like it should be!

enjenjo

A little tip for installing gauges, clamp the area being drilled to a piece of wood. Predrill the holes for the gauge center with a 1/4" drill. Replace the  drill in the hole saw with a 1/4" rod so the center doesn't wander. If using 2 1/16" gauges use a 2" hole saw, and a sanding drum to open it to the finished size.
Welcome to hell. Here's your accordion.

trackster

Thanks for the tip.  Actually planning on recessing an aluminum panel into the dash.  Haven't finalized direction I am going yet.
I am CDO, kinda like OCD, but in alphabetical order, like it should be!