www.speedwaymotors.com has them.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
Rodder's Roundtable / Would a 56 olds motor and hydro trans be too heavy for a mus
June 13, 2005, 09:55:57 PM
Keep in mind that when people refer to having a MII frontend, Unless you are using a boneyard stock setup, they are refering to an aftermarket assembly using the MII suspension geometry. What is on the market today is 30 plus years of technology advancements using tubular A arms, coilovers or airbags, boxed crossmembers, R&P steering, etc, etc. and as mentioned the weight distribution off of the front end is a factor. Most of the failure issues you hear about are from not being properly installed or maintained.
#3
Rodder's Roundtable / Re: Chevy Small Block Motor Mount Question
June 06, 2005, 01:29:12 PM
Depending on how often you do frame mockups, you might consider one of those plastic blocks. Not sure of the cost but just an Idea.
Pages1