Messages

Hi I would like to make my rear window in my truck (46 Dodge) movable but I 'm having a hard time finding a regulator that will work any Idea's

If your hinge is bad I think  its the same body as a half ton I have an extra Russ

Hi did anyone use these wipers did you have difficulty pluming them.there isn't a good way for me to fish the aluminium tubing thru the A pilar with the bends I need to make I was thinking of using copper  tubing insted of the aluminium the cable has to be greased up any way. any thoughts thanks Russ

As a first-time street rod builder, this question comes from ignorance on my part.  On a '37 Ford 2-Dr humpback sedan, do the stock rear window glass channels attached to the regulators have to come out for new glass installation?

I ask because, if not, then I want to install travel limit screws to keep the glass channels from travelling too far up & coming off track from the regulator assemblies during my current mock-up phase; a real pain!

Thanks for any & all input......

Hi there is a screw that holds the window channel on the the rollerstake it of the regulator goes in from the bottom I left the regulator sitting there and then put the window inheld in inplace with duct tape and wood window shims hade to open the regulator to get in the window channel and put the screw back in this took some time and I expanded my vocabulary Russ

Hi well with a better measuring device they are 79/16 and say tilt ray I have a nother one laying around hear some ware had three but the tape holding it on the fender of my truck let go and trying to catch it I smacted it across the room what a move ,lense down ops

Hi what is the size of the lens on the left I have one in my hand thats 71/2 across the back let me Know you pay the shipping Russ

Hi All
Been busy helping a friend with his 37 ford hump back it was a 60sa drag car and all modification was done with a smoke wrench we changed the cross member to a chassi engineering ,the problem is it,sa a four speed car chevy 327 with a m22 trans the cable speedo worked but with an electric speedo there is no room for the pulse gereator to fit between the linkage we need a flexible shaft or an extension where we can make a hole through the cross member and mount the * generator on the out side of the cross member any ideas  Russ

Was there three days seen Bob come in never seen him again but seen his car .I here Bob wone a pize.
I thought it was good some more venders would be nice. Russ

Most of the time I just lurk can't never get across what I mean so I don't reply.After the Wife's passing I just veggatated for a year slowly coming out of it' doing work on a friends 37 ford and building me a Harley from scratch .Ill be a Louiville. Russ (oddjob)