Morris Minor

[Crosley.In.AZ]

I mock'd up the frame rails on one side of the morris.

I may need to modify the rear kick up that is over the differential.  Or change the trunk lid.

this is a universal chassis kit , so not much will fit eggzackly.

[enjenjo]

I like the rear axle.  Looks like there is plenty of rail, should not be a problem to modify them

[tomslik]

looks like a 4 link?


wish i was making progess

[GPster]

I was looking at the Welder Series site and they had a video display of their fabricated rectangular tubing bends. Really neat and they are supplied so that you can get a number of bends out of each kit. Might be worth your while to check it out. He's not only a builder/ supplier but also an RRT member. GPster

[Crosley.In.AZ]

I like the rear axle.  

I've cut off ends of a 9 inch diff I have.. out of a f-150 truck as I recall.

I machined off the axle tube from the bearing end.  See photos.

clik on photos , should enlarge them if you want.