MII alignment specs?

[btrc]

Whats everyone using for alignment specs on Mustang II front suspension?  I have to redo my alignment because the shop that did it didn't tighten the bolts tight enough.  When I built the front suspension I should  have rotated the pivot shaft and set it up for shims but I didn't.

[Mikej]

Bob, Take it back.

[jakesbackyard]

This is according to TCI at their website -

Camber - 1 degree positive
Caster - 2 degrees positive
Toe-In - 1/32" for radials - 1/16" for bias tires

I always set mine at 0 camber and 1/8 toe in, with 2 pos. caster and then let the alignment guy do it to original Mustang specs.

You need to find a competant alignment person you can trust. If they left the nuts loose the first time, do you trust them to do every thing right the next time?

I think I'm getting old, but I have a tough time finding anyone who takes a job they do for you seriously anymore.

Good luck,

[enjenjo]

You might want to consider more caster, in the 6 degree range, it will make the steering much less sensitive.