E brake setup

Started by 2rods, October 13, 2005, 12:53:41 AM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

2rods

Looking for a floor mount center pull ebrake assembly with a 3-4' cable. Does anyone know what OEM units would be similar to this? Thanks.

Kctom

Quote from: "2rods"Looking for a floor mount center pull ebrake assembly with a 3-4' cable. Does anyone know what OEM units would be similar to this? Thanks.

I use the 90 up Camero. Cheap and work great
TOM

2rods

How long is the actual cable? Thanks.

Kctom

Quote from: "2rods"How long is the actual cable? Thanks.

The cable is about 16" but it is threaded on the end, so can make it as long as you need. I made a block of steel 1/2 x 3". Drilled a center hole for the threaded end of the cable. Then drilled a hole on each side of that one 1/8" to accept the brake cable, threaded these two and put 2 set screws in it to hold the cables. You can put a nut on both sides of the center hole to adjust it. This has worked great on all my cars.

TOM