Brake Booster tool

[enjenjo]

Here it is folks. Someone may make one, but I haven't found one yet.  Basically what it is, an H made of 1/2" aluminum, about 4" high, and three inches wide, with a 5/16" by 18 hole threaded in the middle. And a piece of 5/16" all thread rod, 1/16" longer than the height of the H. So if the H is 4" high, the rod will be 4 1/16" long. one end of the rod should be rounded off to work right.

[Bruce Dorsi]

Thanks, Frank!

I have never seen anything like that advertised.

It seems simple enough, yet very effective!


~~~Bruce

[Carps]

Yup, that's what a vac booster tool looks like alright, a little rougher than ours, but a good effort nevertheless.

We've got lots of 'em on our special tools rack.

You should be able to buy one from Lisle Tools or somebody like that.

[Crosley.In.AZ]

where can a person buy internal  parts to rebuild a brake booster?

[Dolly]

where can a person buy internal  parts to rebuild a brake booster?

Some manufacturers actually offer a service or overhaul kit.  Check with your local brak parts specialist or even a franchised dealer for the vehicle your booster was lifted from.