Caster Camber Gauge

[50 F1]

I just got a caster camber gauge and a pair of Snap-On turntables for front end alignment from a friend.

The caster camber gauge is a Ammco 2550. It looks real simple to use. It has about 7 lines of instructions printed on the gauge itself. The writing is right where it was grabbed most of the time during use and the writing is worn off.

I have looked all over the net for info on this gauge with no luck. I found one picture of one on ebay but the writing was worn off in the same place.

Does anyone have any info on this gauge?

Thanks for any Info
Mike

[chris spokes]

 i found this if it works, scroll down

http://www6.grafton.k12.wi.us/ghs/teacher/chader/documents/MicrosoftPowerPoint-A4_Tools_2010.pdf

[50 F1]

Chris

I don't know how you found it but that is exactly the picture I needed.

Much appreciated!

Thanks Mike

[jaybee]

These days it's not just hard to find a shop which will set alignment to your specs, it's getting hard to find people who know how to work on old stuff at all.

[chris spokes]

Chris

I don't know how you found it but that is exactly the picture I needed.

Much appreciated!

Thanks Mike

your welcome ,i just googled it