351 windsor engine swap

[tommy b]

I am installing a 1977 351 Windsor engine into a 1951 Victoria. I have some questions on the electrical wiring. site. The engine I am using has a stock Ford Duraspark II distributor and Ignition module which I want to use. My problem is that I don't know how to wire it in. The distributor has a connector going to the module and the module has another connector going to somewhere in the electrical system. Do I need to use the module or just the distributor? Where do the wires go? If anyone has used this distributor in a swap I'd appreciate some help in hooking it up. Thanks for any info.

tommy b

[enjenjo]

It's easy. There are two wires coming from the module to the body wiring harness.  A red, or red with a white stripe, and a White. red goes to the ignition switch, and white goes to the starter solenoid ign. terminal. If it starts and stalls when you quit cranking, reverse the wires.

[tommy b]

enjenjo,

Thanks a bunch. That's exactly the info I was looking for.

tommy b