New Tool

Started by enjenjo, May 02, 2006, 08:19:34 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

Print
Go Down Pages1
User actions

enjenjo

May 02, 2006, 08:19:34 PM
New to me of course. I am assembling a 40 Ford banjo rear, and had to replace the axle seals, Waaaay up inside the housing. So I wipped up a long seal driver on my lathe, out of some scrap I had laying around. Took an hour to make the driver, one minute to install the seals.
Welcome to hell. Here's your accordion.

Crosley.In.AZ

#1
May 02, 2006, 08:50:21 PM
good job,  atta boy.
Tony

 Plutophobia (Fear of money)

Bib_Overalls

#2
May 03, 2006, 12:46:46 AM
Can I borrow it?
An Old California Rodder
Hiding Out In The Ozarks

Leon

#3
May 03, 2006, 12:50:37 AM
Quote from: "enjenjo"Took an hour to make the driver, one minute to install the seals.
Isn't that about the way it usually works?  I spent 4 hours turning new dies for my bead roller to make a replacement piece for the floor pan, about 3 minutes to roll in the ribs.  At least I have it the next time I need that shape rolled in a piece of metal.
Print
Go Up Pages1
User actions