Its the weekend are you gonna do anything?

[kb426]

I didn't want this thread to die. We've kept in touch with each other pretty well through the years with this. Today I removed the 3550 from the 32 and replaced the tailshaft bushing. I'm taking a break and ready to put it all back together. The wind was blowing about 40 mph so it's not a bad day to be in the shop. The bushing went out and in without any trouble. I had the new one in the freezer for a while and the heat gun on the housing. It's really tight around the crossmember so it's not much fun to work on. I looked real close to see if there was anything else that needed attention while it was out. It all looks pretty good. This was a used trans that I bought when I built the truck. I'm hoping that this will be the last time the trans comes out for any reason. I've put 6,000 miles on it since I finished it. I hope that in about 50,000 more, I can say that it's still all good. I'm ready to drive without that stupid leak.

[phat rat]

I've got the new motor in the cpe and driving it. Been working on wiring the dually for trailer hauling and cleaning up some of the wiring someone had done

[alchevy]

Well the temp job that I had at the same place my wife works at only lasted a month, but it was more than unemployment, so that was good. My wife will be going on staff there May 1st so she has a future there. There is something out there for me, so I will keep looking.

Missed the Bunny Run this year. Even though I had pre-entered, have to try again next year.
AL

[enjenjo]

Denise came down and picked up her Olds deck lid that will be her awning. It arrived here on a HAMB relay last month.

[Crosley.In.AZ]

fixed  some landscape lights this afternoon

installed different  rear gear ratio into the Falcon  this past week

[39deluxe]

I get to figure out why the dish washer flooded the kitchen.  :evil:

[UGLY OLDS]

Still trying to organize the garage ... :?   It's gettin pretty busy in there ........

If I had a another place to park there would be lots of room.....  


Visited a garage sale & picked up some small carbide burrs...Cleco's & misc calipers & stuff...Old timer type guy sells stuff for 10 cents ....50 cents...."Clean" tools for a dollar or less...He "collects" stuff all year for his yearly garage sale ....He needs the companionship MUCH for than I need the tools ...Fun guy to talk to.....


 


Bob............

[kb426]

I put 110 miles on the 32 today. The trans leak is fixed. At least for now.  
I serviced the snow blower and put it up for the summer. I'm done with winter.