more progress on the 32

[nzsimon]

I decided to make some stainless trim to fill in the recess in the grill shell where the side panels would go if I had any

3 pieces of stainless tigged together and a lot of finger burns and one side is done now I have to polish it and do the other side

The hood isn't closed in this shot hence the huge gap

[nzsimon]

here is the first side polished made the other side yesterday

[enjenjo]

Just keep it up Simon, and you are going to run out of shiney bits to make.

[nzsimon]

Here is the finished article just temp bolted on needs a bit of fine tuning but it looks better than the gap

[nzsimon]

Here is my next shiny bit I was lucky to get the father in law to fold a piece of stainless so I could make this cover in the boot area

It is white because of the protective film on it

I plan to sandblast the ford logo into it

[nzsimon]

An Hour later it looks like this