Morris Minor

Started by Crosley.In.AZ, August 04, 2008, 10:52:32 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

Crosley.In.AZ

I mock'd up the frame rails on one side of the morris.

I may need to modify the rear kick up that is over the differential.  Or change the trunk lid.

this is a universal chassis kit , so not much will fit eggzackly.
Tony

 Plutophobia (Fear of money)

enjenjo

I like the rear axle. :D  Looks like there is plenty of rail, should not be a problem to modify them
Welcome to hell. Here's your accordion.

tomslik

looks like a 4 link?


wish i was making progess :roll:
The last thing I want to do is hurt you. But it\'s still on my list

GPster

I was looking at the Welder Series site and they had a video display of their fabricated rectangular tubing bends. Really neat and they are supplied so that you can get a number of bends out of each kit. Might be worth your while to check it out. He's not only a builder/ supplier but also an RRT member. GPster

Crosley.In.AZ

Quote from: "enjenjo"I like the rear axle. :D  

I've cut off ends of a 9 inch diff I have.. out of a f-150 truck as I recall.

I machined off the axle tube from the bearing end.  See photos.

clik on photos , should enlarge them if you want.
Tony

 Plutophobia (Fear of money)