GM 8.2 10-bolt rear end pinion yoke question

[Kobies Kool 40]

I have searched and searched :?  :?  and am having a heck of a time.  I need the 25 spline pinion yoke that will accept the 3-5/8 u-joint (I believe this is known as the 1350 series??).  I've searched the net but cannot find anything that calls out this combo.  I think I can get the u-joint with the smaller end for this rear but have heard that these won't hold up as well.  Any advise is appreciated.

Thank you much,  Shawn

[enjenjo]

mid 70's midsize GM wagons.

[Dr Flowgood]

Hi  Doug from Dexter here.  (round the corner from 348 tripower )
The 8.2" chevy 10 bolt is a fairly light duty rearend , I wouldnt worry about finding a 1350 yoke for it. Chances are a more normal1310 (or whatever the spicer style is) will be stronger than the rear itself.   The 8.5" 10 bolt rears like used in 71 and up F bodies ect are MUCH MUCH stronger and then might warrant a 1350 joint if you were drag racing.

Doug Jaynes
I was at KZOO too!