I need some Sanden compressor dimensions.

[zzford]

Does anyone out there have the dimensions of a Sanden 508 A/C compressor with serpentine belt? I need the measurement of the rearmost surface of where the belt rides to the inside of the front mount, and the measurement between the mounts. The compressor that I'm referring to is the universal compressor with the mounting ears. Thanks, Fred

[Harry]

Vintage Air website may have something.

[wayne petty]

this site shows some of the clutches..

http://www.polarbearinc.com/PBPC/homepage/Search/CL/CL_Dimen_Sanden.html

http://www.polarbearinc.com/PBPC/Homepage/Search/Co/CO_Sanden_Cross.html


distance between the mounting ears is 83.3MM  my converter shows that as 3.279" .....


you might want to download this 1.7 meg pdf file if you don't already have it..

http://www.sanden.com/originals/images/SD_Service_Guide_Rev.2.pdf



this one has even more info .. and individual pictures ... a handy for any rodders hard drive...

http://www.heco.net/maincat/compressors.pdf

[zzford]

Thanks, Wayne. I really need the measurement from the rear of the belt surface to the inside of the mouunting ear. I want to built a compressor mount and I need this measurement to be sure the belt will line up with the existing pullys.

[papastoyss]

Does anyone out there have the dimensions of a Sanden 508 A/C compressor with serpentine belt? I need the measurement of the rearmost surface of where the belt rides to the inside of the front mount, and the measurement between the mounts. The compressor that I'm referring to is the universal compressor with the mounting ears. Thanks, Fred

I have one on my project at home. I'll get the specs for you tonight & post them tomorrow if CRS doesn't set in.

[kb426]

I'll try tonight also. CRS.

[zzford]

Thanks, guys. You guys rule!

[papastoyss]

Does anyone out there have the dimensions of a Sanden 508 A/C compressor with serpentine belt? I need the measurement of the rearmost surface of where the belt rides to the inside of the front mount, and the measurement between the mounts. The compressor that I'm referring to is the universal compressor with the mounting ears. Thanks, Fred

I have one on my project at home. I'll get the specs for you tonight & post them tomorrow if CRS doesn't set in.

Try this, distance between ears front to back is 3.275" , distance from back of front mounting ear to rear of clutch pulley is 1.440". My clutch pulley is 1.074 wide w/7 grooves which might give you a little wiggle room. Remember the holes in the mount ears are 10mm, a 3/8 bolt will be a little loose in the hole. Hope this helps, I've got a lot of good advice here, it's a good feeling to be able to help someone else.

[zzford]

Papastoys, thank you so much! I REALLY appreciate your help.  Thanks again to all of you guys for making this the "go-to-site".