Hammer forming

[enjenjo]

I have to make a splash apron. Is there any interest in a Hammer forming tutorial?

[chris spokes]

always keen to learn something

[moose]

YEP!!

[unklian]

Yes.

[parklane]

Me too.

[river1]

yup!! i ain't dun learnin, that'll happen if i die.

later jim

[UGLY OLDS]

Count me in ...I love makin' stuff with a hammer .....  :?


Bob.........

[zzebby]

Amazing what this guy can do........yes I want to see this too.  What gauge are you starting with and is it just ordinary cold rolled or aluminum killed or ? ........or aluminum ?

[enjenjo]

Amazing what this guy can do........yes I want to see this too.  What gauge are you starting with and is it just ordinary cold rolled or aluminum killed or ? ........or aluminum ?

18 ga cold rolled steel. Unless there is a lot of shape, AK steel is not needed.  I'll post the start of this project tomorrow.

[OldSub]

I have to make a splash apron. Is there any interest in a Hammer forming tutorial?

Absolutely!  I have to replace one end of a splash apron and assumed hammer forming was the right approach.

I'll be looking forward to seeing it.

Thanks!

[chimp koose]

take us to school!!!!

[Crosley.In.AZ]

seems like you did a simple hammer  form project a few years back.

this sounds much more complicated..  :!:

cant wait... hurry

[rog]

did this go ahead? would like to see the outcome  

[enjenjo]

did this go ahead? would like to see the outcome  

Yes it did, it's on down the page.

[rog]

thanks frank, found it. excellent article, very informative