Messages

I Have an old Page I made with some buick stuff.
I just never kept it up .. The ST8 stuff is not up enough
for me to spend much time with the posts...
anyway. Here is the link.
http://woodgraining.com/HAMB/
Ryan Knows about it  
Jdee

I did not make those, they are from Jyrki's Buick Site
He sent the photos to me to check out.
http://gamma.nic.fi/~marlin/Rmaster.htm

I'm still working on the interior sheet metal in my Buick
It had sliding quarter windows, so I got a little more work than I thought to do after the chop    
Jdee

You are not alone, I'm looking for the same thing
Would like to find an edmunds intake , but the only ones I find
are for the Big 320s

I do have to make these headers, with a nice Intake
the ST8 would look sweet.
Jdee

Hi, have you seen this site.
http://www.fibreglast.com/
It has some good info on this.
Jdee

Click the firewall tab then the zones tab then at the bottom hit ADD then add the Ips of the other computers. to the trusted network. That worked for mine.
Not sure for yours .
Jdee

Thanks A bunch..

One other thing, what do you use to make your
Glass templates?
1/8" MDF or something like that.
I'm lucky all my glass is flat.
Jdee

Do I buy the rubber for the car and just cut it and let it go?
or is there a way to Glue the modified rubber together?
Thanks Jdee

Make sure the lacquer is real dry!
Or it will not work.
Lacquer dries from the top down so it might seem dry
But still has solvent in the lower layers this will gas out and delaminate
the Uro topcoat, But if its good and dry it will work just fine.
Jdee