Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - Coupen

#1
Rodder's Roundtable / steering wheel shake w/M II
May 28, 2009, 11:47:28 AM
PMFJI,

 Have you checked the play in the lower steering column bushing/bearing?  Excessive play tends to allow movement in the linkage and abnormal movements at the steering wheel.

Regards,
                 Ron . . .
#2
Rodder's Roundtable / Classic Gauge Problem
May 03, 2006, 12:42:18 PM
I also had this problem on both my Classic quad guage, speedo and tach.  I drilled a couple of vent holes about 1/8 -3/16 diameter in the plastic case near the bezel.  I made sure the holes faced up when the guages were installed so the moisture vapor could rise up and out of the case.  I did this a couple of years ago and have not noticed any foging since.

Regards,
               Ron . . .
#3
Sorry about the picture size, it was the only one I had at work when I wrote the message.  On the other hand, the cab does seem to be a little cramp . . .


Ron . . .
#4
Hi Root,

I also have a '35 pick-up.  Always like to talk pick-up's.  My truck is pretty much complete (finally).  Basics:   296 cu in flatmotor, C-4 tranny, MII front end, Ford 8" triangulated four link rear suspension.  My better half has a '35 3W coupe with a SBC.

Regards,
              Ron . . .
#5
Hi Root,

I also have a '35 pick-up.  Always like to talk pick-up's.  My truck is pretty much complete (finally).  Basics:   296 cu in flatmotor, C-4 tranny, MII front end, Ford 8" triangulated four link rear suspension.  My better half has a '35 3W coupe with a SBC.

Regards,
              Ron . . .