Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - chromeblvd

#1
Rodder's Roundtable / Re: 700R4 different types?
March 20, 2006, 11:40:25 PM
Sounds like the t-400 has morning sickness.... aka hard internal seals . When cold the seals  do not hold pressure till some warmth gets in there.

The tranny could need a full over haul.

have fun.[/quote]

Thanks Guys!!! I will dig deeper in my pockets to get the tranny rebuilt.  Just ordered a new engine this morning... haha, when it rains it pours... :(D) ouch!
#2
Rodder's Roundtable / Re: 700R4 different types?
March 20, 2006, 08:15:54 PM
My pull vehicle is an 89 chevy suburban 4x4 with a 350 engine and turbo 350 transmission sitting on 35" tires.

Correction... it has a TH400 not a TH350 as one guy had pointed out for me.  I just got done comparing and it's a TH400.  It only has problems in cold weather.  The truck needs to warm up before engaging into drive or reverse. Is there a particular reason for this??  Is this a repair job for the DIY??  Or should I just take it to the tranny shop and be done with it?
#3
Rodder's Roundtable / 700R4 different types?
March 20, 2006, 03:21:29 PM
Hey gang! Very new here.  I've read a lot of posts (including the 700R4 site...which led me here... :D )but haven't been able to find the correct answer. :?   My pull vehicle is an 89 chevy suburban 4x4 with a 350 engine and turbo 350 transmission sitting on 35" tires.  I'm in need of a transmission rebuild... should I just rebuild what is there or upgrade to a 700R4 (getting an overdrive)?  Currently, at its best the truck gets 11.5 mpg.  Obtaining an OD may help toward fuel costs.  In my search I came across this link http://www.fearthemonster.com/transmissions/monsterminion/stock/700r4/ which shows two different types of 700R4 transmissions.  My brother has a 700R4 on the shelf.  He planned on using it a while back but changed his mind.  I haven't seen it and the cost is just right.  Until the link above, we didn't know there were two types of 700R4's.  Can anyone tell me the crucial difference between them?  Besides the obvious-one is for two wheel and the other is for four wheel drive applications.  ie... difference in gearing, bolting to engine, shortening/lengthing of the driveshaft??? It appears by the photo that the four wheel drive is shorter.  But are these photos accurate?  Without having the two side-by-side, we don't know which one we have.  Will either one work?  Just trying to eliminate additional work.  Any help on this matter will be greatly arreciated.  Thank you!