I am building the english wheel described on this site. I am having a hard time finding a Double D shaft and tubing. Does anyone know what I can use to substitute for this?
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#1
Rodder's Roundtable / Need Substitute for Double D Shaft and tubing
February 18, 2006, 10:19:23 PM #2
Rodder's Roundtable / English wheel bearing source
February 16, 2006, 09:31:11 PMQuote from: "enjenjo"The bearing is about an inch wide, and 3" diameter. It can be obtained at an auto supply store. It is listed as an axle bearing for an 8" or 9" ford rear end. the part number is RW-207CCRA
Thanks Enjenjo. I am not up on cars so I go a little confused with the description. I need the English whhel to shape some parts for my chopper.
#3
Rodder's Roundtable / English wheel bearing source
February 16, 2006, 09:06:57 PM
Does anyone know where I can purchase the top bearing for the english wheel plans posted on this site. All the ones I have found are no where near 8"-9".
Pages1