Topics

I need someone to haul a car from Houston TX to Pembina ND preferably in a covered trailer. Anybody got any contacts they want to share. Thanks in advance.

I had my 04 dodge ram in the tranny shop today, when they pulled the pan they said the oil was orange and couldn't explain how it could get that color anybody here have any iderrrs!!!

Is there anybody near Jacksonville FL that could have a look at a piece of equipment for me.

I've adapted a Ford truck power steering box to an old tractor and now want to hook up the hydraulic lines, but I have to know what the line pressure is on a mid 80's Ford F250 power steering pump. I want to use the tractors hydraulic pump with an in line regulator. Any help is always appreciated.

Does anybody have any experience with the TH350C, what are the draw backs to putting the lock up on a switch? I've been thinking about changing to one of these to pull my revs down on the highway, any comments welcome TIA.

I stopped by a friends welding shop today and found out he had torn the motor out of his forklift, he had the block and heads sent out to be redone and had started to reassemble the thing. The problem is he doesn't have a manual and is not that familiar with engines, I can help him out a bit but I just had surgery and am not that mobile yet. I'm almost positive he doesn't have the timing right as the marks on the crank and cam sprockets don't line up to anything. Does anybody know where I can get on line info on the thing: best guess is that it's a 82 Toyota R5 engine??

I want to change my vacuum wiper motor to electric, I was told that JC Whitney had the direct replacement motors. But when I went to their site it says the motors are for 41 to 48 Chevs and mine is a 40. Will this still work or is there a difference between 40 and 41.

TIA
John

I'm doing a new frame for my 40 Chev, I've used MII for the front end the donor was a 77 Bobcat, my question is: should I use the original springs or should I purchase springs that were used on V8 Mustangs.

TIA
John