Print Page - more progress on the 32

Title: more progress on the 32
Post by: nzsimon on February 06, 2009, 11:18:14 PM

I decided to make some stainless trim to fill in the recess in the grill shell where the side panels would go if I had any

3 pieces of stainless tigged together and a lot of finger burns and one side is done now I have to polish it and do the other side

The hood isn't closed in this shot hence the huge gap

Title: .
Post by: nzsimon on February 08, 2009, 08:43:02 PM

here is the first side polished made the other side yesterday

Title: more progress on the 32
Post by: enjenjo on February 08, 2009, 09:02:17 PM

Just keep it up Simon, and you are going to run out of shiney bits to make.

Title: .
Post by: nzsimon on February 13, 2009, 04:17:49 PM

Here is the finished article just temp bolted on needs a bit of fine tuning but it looks better than the gap

Title: more progress on the 32
Post by: nzsimon on February 13, 2009, 04:22:13 PM

Here is my next shiny bit I was lucky to get the father in law to fold a piece of stainless so I could make this cover in the boot area

It is white because of the protective film on it

I plan to sandblast the ford logo into it

Title: later
Post by: nzsimon on February 13, 2009, 08:24:38 PM

An Hour later it looks like this

The Rodding Roundtable

Motorhead Message Central => Rodder's Roundtable => Topic started by: nzsimon on February 06, 2009, 11:18:14 PM