The Rodding Roundtable
Motorhead Message Central => Rodder's Roundtable => Topic started by: tomslik on January 12, 2007, 09:57:55 AM
here's what i got:wdt-aa
3L00 80A 299
i know it's a 3.00 posi BUT is it a 9" or 9 3/8"?
IF it's a 9 3/8, is it ok to modify the 9"housing to fit?
Quote from: "tomslik"here's what i got:wdt-aa
3L00 80A 299
i know it's a 3.00 posi BUT is it a 9" or 9 3/8"?
IF it's a 9 3/8, is it ok to modify the 9"housing to fit?
It is a 9 3/8" housing. It is out of a 1967 Thunderbird and it has 31 spline axles.
Are you trying to put this carrier into another housing? If so that should be OK once you cut the notches for the ring gear to pass through.
Quote from: "Fat Cat"Quote from: "tomslik"here's what i got:wdt-aa
3L00 80A 299
i know it's a 3.00 posi BUT is it a 9" or 9 3/8"?
IF it's a 9 3/8, is it ok to modify the 9"housing to fit?
It is a 9 3/8" housing. It is out of a 1967 Thunderbird and it has 31 spline axles.
Are you trying to put this carrier into another housing? If so that should be OK once you cut the notches for the ring gear to pass through.
Etiher your a dam genius or ya got a good book
Dave :arrow: :wink: :lol:
it sure does fit with minor mods although the flange (not a yoke) tells me the dates may be off...
thanks!
Quote from: "tomslik"it sure does fit with minor mods although the flange (not a yoke) tells me the dates may be off...
thanks!
yep it will fit as you now know.
good luck,
best to you
Quote from: "jusjunk"Either your a dam genius or ya got a good book
Dave :arrow: :wink: :lol:
Yep :roll: