changing a 6V pos ground to 12V neg questions

Started by tomslik, November 18, 2023, 10:53:39 AM

Previous topic - Next topic

0 Members and 3 Guests are viewing this topic.

tomslik

(51 F-3 ford) painless wiring, stock gauges.
it occurred to me last night that this could be an issue. has anybody successfully made the gauges work?
new temp sender reads hot, oil reads 0, fuel gauge reads F and it's not.
new tank and sender, new temp sender, oil is original....ideas?
The last thing I want to do is hurt you. But it\'s still on my list

kb426

When I was young, people used a voltadrop resister to go from 12 to 6 volts. Outside of that, I'm no help. :)
TEAM SMART

tomslik

yeah, did that. i suspect it has to do more with the polarity
The last thing I want to do is hurt you. But it\'s still on my list


kb426

I had a thought: could you connect a power window switch that reverses current and run it to the gauges through it?
TEAM SMART

enjenjo

On my 52, same gauges, I just reversed the polarity, and installed a 56 Ford instrument voltage regulator in line. I made no other changes. It never was a problem. The only thing I had a volt-a-drop on was the electric wipers.
Welcome to hell. Here's your accordion.

tomslik

The last thing I want to do is hurt you. But it\'s still on my list

tomslik

The last thing I want to do is hurt you. But it\'s still on my list

Crosley.In.AZ

If the sensor is not matched to the old gauge, will they work at all ?
Tony

 Plutophobia (Fear of money)

tomslik

it should be, it's all new for the truck (lmc)
The last thing I want to do is hurt you. But it\'s still on my list

kb426

Just for a test, how about connecting a 6 volt battery charger to them and see what happens?
TEAM SMART

tomslik

The last thing I want to do is hurt you. But it\'s still on my list

enjenjo

Positive to the gauge power, negative to the ground. if you are using a generator you have to re-polarize the generator, and use a 12 volt regulator. I had an alternator on mine.
Welcome to hell. Here's your accordion.

tomslik

i've changed it to a gm alt (speedway bracket), tried isolating the gauges from the housing and going positive ground (might've killed a gauge or 2...)
could it be that the bigger trucks were already negative ground?
The last thing I want to do is hurt you. But it\'s still on my list

enjenjo

 I used one of these  https://www.dennis-carpenter.com/bronco/electrical/battery/b9mz-10804-c-instrument-cluster-voltage-reg  and wired the gauges as stock , just reversing the polarity. I have done this on various Fords and it has worked every time. You can use a 0 to 200 Ohm potentiometer to test the gauges out of the truck. If you reverse the power and sender terminals on the gauge you can damage the movement.

The big trucks were positive ground until they switched to 12 volts.
Welcome to hell. Here's your accordion.